Network and Device Settings
TPG User Manual 27
Configuring IPv4 Parameters via the InterCon-NetTool
Requirements
; The InterCon-NetTool is installed on the client, see: Ö20.
; The network scan via Multicast has been enabled in the
InterCon-NetTool.
; The router in the network forwards multicast requests.
Proceed as follows:
1. Start the InterCon-NetTool.
2. Highlight the TPG in the device list.
The TPG is displayed in the device list under 'ZeroConf' with an IP address from
the address range (169.254.0.0/16) which is reserved for ZeroConf.
3. Select Installation – IP Wizard from the menu bar.
The IP Wizard is started.
4. Follow the instructions of the IP Wizard.
ª The settings are saved.
Fig. 5: InterCon-NetTool - IP Wizard
Comments to this Manuals